Navigation

Use our 2-pin replacement power cable with your GPSMAP® 4000/5000.

Use our 2 m (6.56 ft) NMEA 2000 power cable to provide power to your NMEA 2000 network.

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator...

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator...

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator...

This mount attaches to any flat surface and is easily adjusted for optimal viewing. Screws not included.

This is a SeatalkNG starter kit consisting of T70134 STNG STARTER KIT Consisting of: A06064 STNG 5-WAY CONNECTOR A06031 STNG BACKBONE TERMINATOR (x2) A06040 STNG SPUR CABLE, 3M A06049 STNG POWER CABLE, 2M

This has a RayNet Female connector at one end and a RJ45 Female Gland connector at the other end. The Gland makes the RJ45 Female socket watertight. A typical use for this cable would be to convert a "RJ45" Digital Radar Cable to a "RayNet" Radar Cable,...

This 4 meter cable has a female micro C NMEA2000® connector on one side and a simnet connector on the other.

This 1 meter cable has a female micro C NMEA2000® connector on one side and a simnet connector on the other.

The Raynet to RJ45 Ethernet (M) adapter can be used to connect new c and e-Series MFDs to the SR6 or 8-Port Seatalk High Speed network switch. When used in conjunction with a crossover coupler, this adapter can also convert the Ethernet connection on a...

The Raynet to RJ45 Ethernet (M) adapter can be used to connect new c and e-Series MFDs to the SR6 or 8-Port Seatalk High Speed network switch. When used in conjunction with a crossover coupler, this adapter can also convert the Ethernet connection on a...