Drop-In Interchangeable Hub Propellers

The 11 3/8X12 A3R PROP by Polastorm Series is an aerospace casting technology breakthrough for marine aluminum propellers that is high-quality and extremely strong. This propeller fits YAMAHA 25-60HP with 13 spline tooth shafts, T25hp (after 2010), and...

The Polastorm 11 3/8X14 A3R PROP is a three-bladed, 13 tooth splines and high-quality right-hand propeller that suits HONDA BF35/40/45/50/60HP and Suzuki Engines 35-65HP. It employs the latest aerospace casting technology for marine aluminum propellers,...

The Polastorm 11 5/8X12 A3R PROP is a high-strenght creation of aerospace casting technology for marine aluminum propellers boasting combination casting of strontium, aluminum, and titanium that are far more substantial and more enduring than standard...

This product replaces:14984017466

80908-CB HUB ONLY

The Forward Thrust Washer is for select motor applications. This is compatible with Xhs II Hub Kit 201, 202, and 226. Its function is to make clearance between the gearcase and the propeller hub. Without it, the propeller would rub on the gearcase...

Thrust Washers for Yamaha 40-60 HP (991243) Michigan Wheel is a flat washer used to connect a revolving surface to a stationary component. They sustain the axial load or side-to-side motion on a shaft preventing movement along that shaft. The thrust...

Worn-out or nicked thrust washers can cause damage to the propeller shaft and blade face. When repairing or checking your propeller, you should replace the thrust washer to protect your drive system. This 991247 forward thrust washer is designed for use...

The Michigan Wheel aft castle was designed exclusively for Mercury Mercruiser V6 outboards. The Michigan Wheel Aft Castle Washer supports the steering post structurally, eliminating sag and improving boat control. This unit's huge footpad surface...

If you don't have one, your propeller may be slipping. It only aids in preventing cavitation and, in the worst-case scenario, complete blow-out of a thru-hub exhaust system by keeping the exhaust gases in the slipstream (the water flow between the bottom...

The diffuser ring keeps exhaust gases from re-entering the blades at low speeds. If you don't have one, your propeller may be slipping. Only on a thru-hub exhaust system do they aid to keep the exhaust gases in the slipstream (the flow of water between...