Installation Accesories

Molded nylon encases 6 or 12 pairs of connectors that use screw compression to secure wires without use of lugs. ideal for electronic installations. Brass barrels capture wires and are held in place with a stainless steel ?finger" compressed by a screw...

Molded nylon encases 6 or 12 pairs of connectors that use screw compression to secure wires without use of lugs. ideal for electronic installations. Brass barrels capture wires and are held in place with a stainless steel ?finger" compressed by a screw...

Ideal as a DC ground tie point or positive bus, these heavy duty, 500 amp rated bus bar assemblies feature 5/16" studs on 1" centers in 1/4" thick copper bar for common connection/distribution of large wire gauges and accommodate 5/16" ring terminals...

Ideal as a DC ground tie point or positive bus, these heavy duty, 500 amp rated bus bar assemblies feature 5/16" studs on 1" centers in 1/4" thick copper bar for common connection/distribution of large wire gauges and accommodate 5/16" ring terminals...

Ideal as a DC ground tie point or positive bus, these heavy duty, 500 amp rated bus bar assemblies feature 5/16" studs on 1" centers in 1/4" thick copper bar for common connection/distribution of large wire gauges and accommodate 5/16" ring terminals...

Model Cable Diameter Range Max Connector Diameter Typical Connector CCX-R .47"-.59" 1.57" Large Radar Plug CCX-S .35"-.55" .83" Small Radar Plugs CCX-T .18"-.35" .83" PL-259, BNC, Wind...

Waterproof Junction Boxes Ideal for making wiring connections above or below decks, even in areas subject to occasional spray Similar to BX Series junction boxes, but made from rugged, non-corrosive, high impact polypropylene Snap-on cover provides...

Waterproof Junction Boxes Ideal for making wiring connections above or below decks, even in areas subject to occasional spray Similar to BX Series junction boxes, but made from rugged, non-corrosive, high impact polypropylene Snap-on cover provides...

Waterproof Junction Boxes Ideal for making wiring connections above or below decks, even in areas subject to occasional spray Similar to BX Series junction boxes, but made from rugged, non-corrosive, high impact polypropylene Snap-on cover provides...

The Emergency Relay/Charger is a device for assuring immediate back-up power to communications equipment in the event AC power is temporarily lost to the power supply or the supply fails. In addition it will allow the power supply to act as a ?trickle?...

Terminal Strips Use as a common negative/neutral bus for AC or DC systems. Dual terminal strips in 4 or 8 screw positions on 3/4? centers are secured to a high density insulated base. All hardware, bus material and fasteners are nickel-plated brass. #8...

RA Series Right Angle Waterproof Feed-Thru Fittings Route cables at 90° through vertical and horizontal surfaces with wall hugging low profile design that keeps cable secured close to the surface reducing intrusion with personnel or other equipment...